Request: Low-High Boost Cut Feature

The Spectacle · Post by **The Spectacle** » Tue Sep 07, 2010 5:43 am

Curious if there are plans to change the hot boost cut in the protection tab to a conditions based value, based on whether low or high boost is selected in the boost control paramaters. Am I correct in saying that as it stands right now, whatever psi you have for high boost cut is universal no matter which table you're in (high or low)?

Post by **Spunkster** » Tue Sep 07, 2010 11:04 am

That is correct. There is no plan to change this.

The Spectacle · Post by **The Spectacle** » Tue Sep 21, 2010 6:14 am

Can you guys look into it? Seems simple enough to implement. Would make it very convenient to have a low/high boost switch wired in without having to have a laptop to change the boost cut when switching boost levels