turbo cal needed for obd1 gsr motor
stg 1 crane cams
91 oct
57 trim turbo
2.5" ic piping
880cc precision injectors.
7-8lbs of boost
9.5.1 compression.
ANYONE HAVE A CAL FOR THIS? PLZ :D
gsr turbo cal needed
B18C cal
Ill try to DL my cal tomorrow and post it for you. Theres a couple differences in my setup so if you use it its at your own risk.
1. Old turbonetics turbo 50 a/r (the one from the first civic/integra kit)
2. GSR cams on a gsr head (ported and polished)
3. Edelbrock Victor-x intake mani w/ throttle body
4. Turbosmart BOV, Tial WG
5. 1000cc inj @ 42 psi (but you can use smanager to recalc for your inj)
6. Disp increased to 2.0L Forged Internals, Sleeved block, Stock crank.
7. I use a 2 stage boost controler. 5psi low 20 psi high
8. Dished low comp pistons 8:1
I recommend using a wideband so you can ensure its not too lean for your setup.
1. Old turbonetics turbo 50 a/r (the one from the first civic/integra kit)
2. GSR cams on a gsr head (ported and polished)
3. Edelbrock Victor-x intake mani w/ throttle body
4. Turbosmart BOV, Tial WG
5. 1000cc inj @ 42 psi (but you can use smanager to recalc for your inj)
6. Disp increased to 2.0L Forged Internals, Sleeved block, Stock crank.
7. I use a 2 stage boost controler. 5psi low 20 psi high
8. Dished low comp pistons 8:1
I recommend using a wideband so you can ensure its not too lean for your setup.