Flashpro not recording cranking datalog

civicRSA · Post by **civicRSA** » Thu Aug 26, 2010 1:36 am

When I try to datalog and record to the flashpro unit while cranking it stops datalogging as I crank. If I record to the laptop it is fine.
Is there a solution?

Post by **Spunkster** » Thu Aug 26, 2010 10:36 am

Your battery voltage is to low when cranking more than likely.

civicRSA · Post by **civicRSA** » Thu Aug 26, 2010 10:52 am

Possibly. My car was standing for 4 weeks but I have done a lot of driving the last few days so it should be charged well.

I have also relocated it to the trunk but the cable thickness is enough.

I noticed the power led on the flashpro flashes off/on once when I crank.

Post by **Spunkster** » Thu Aug 26, 2010 11:19 am

The problem is that you have relocated the battery. This causes a decrease in voltage.