K24A1 with K20Z1 head / Brian Crower Stage 2 cams. Need Map

k20z3si4dr · Post by **k20z3si4dr** » Tue Aug 10, 2010 3:22 pm

K24A1 block
K20Z1 head
Supertech dual valvesprings
Supertech flat valves
Brian Crower Stage 2 cams
09 TSX pistons 11:1
PRB intake manifold
AEM V2 intake
DC Sports Race header
2.5" catback exhaust

Im really looking for a calibration..... I prefer one that is tested, and not one that someone just cobbed together. How would the K20 Brian Crower stage 2 map that comes with K-Pro work with added fuel to the entire map? I dont want to run a full 50 degree VTC either, even tho I am running one. Id prefer to top out at around 35.

k20z3si4dr · Post by **k20z3si4dr** » Wed Aug 11, 2010 8:15 am

come on people. 10 views and no map? wtf?

icebox434 · Post by **icebox434** » Thu Aug 12, 2010 4:04 am

if you want a good tune, pay for it. otherwise man up and make your own.

k20z3si4dr · Post by **k20z3si4dr** » Fri Aug 13, 2010 9:14 pm

icebox434 wrote:if you want a good tune, pay for it. otherwise man up and make your own.

read the original post. I am looking for it so I can get to the tuner. Nobody asked opinions, instead I asked for a calibration. If you dont have it... dont post. simple as that.

icebox434 · Post by **icebox434** » Mon Aug 16, 2010 4:18 am

k20z3si4dr wrote:
icebox434 wrote:if you want a good tune, pay for it. otherwise man up and make your own.
read the original post. I am looking for it so I can get to the tuner. Nobody asked opinions, instead I asked for a calibration. If you dont have it... dont post. simple as that.

i did read the original post and it never said anything about getting to the tuner, there are base calibrations in kpro for a reason and not many people are going to want to give up a "tested cal" because it most likely is one they payed for.