2 dead k-pro. Why?

[Umran]

I have ek with k20a2 running on PRC + kpro.
And now i have 2 dead k-pro in 2 month.
First is made 02\08, serial 5005181, rev13d.
Second a bit far from me.
I'm from Russia, Moscow. Our (russian) dealer can say nothing about this, so i write here.
Every hondata works about 1 month(the first was about 3 years used and second was absolutely new).
I have to say that i used to run it with my notebook about 80% of time. But after death usb interface still working.

I had an expirement after that : took third kpro, and replaced main processor form third to my first dead. First kpro starts and works fine, so the problem is here - processor burn or somthing.
So the question is - why processor can burn?

[Spunkster]

It sounds like you have major problems with the wiring in the car. I would suggest you start from scratch on the wiring.

[Umran]

It sounds like you have major problems with the wiring in the car. I would suggest you start from scratch on the wiring.

So i i'm about get full check of electricity with man who made it while swap was.. in tuseday. Then i write again.
Is there any chance that my notebook kill hondata? Can the problem be in my alwayse ride with notebook online with hondata(i'm watching temperatures this hot summer and fighting with overheating..). I have to point that i had never any dead usb device with it.
And second question - do u can to sell me processor and ship send it to my so i can repair my kpro?

[Spunkster]

The laptop should not damage the K-Pro. We do not sell parts.

[Umran]

The laptop should not damage the K-Pro.

Okay.

We do not sell parts.

Do u can repair my hondatas if i send them to you?

[Spunkster]

What are the serial numbers of the K-Pro boards?

[Umran]

First is made 02\08, serial 5005181, rev13d.

the second is not with me now.
i can tell it in 2 days