Wideband Wiring

spoonskywalker · Post by **spoonskywalker** » Wed Jun 23, 2010 11:57 pm

Hi...

I got ELD error after installing the PLX WB. Should I cut the wire from ELD and just connected the WD input from PLX WB only?? Currently I jumper the wire from PLX WB to the D10 (ELD) pin.

Post by **Spunkster** » Thu Jun 24, 2010 9:21 am

http://www.hondata.com/techplxwiring.html

spoonskywalker · Post by **spoonskywalker** » Thu Jul 01, 2010 1:22 pm

White 0-5V Output from wideband - connect to ELD input making sure that the ELD is no longer connected to it (ELD is pin D10 on an OBD1 ECU) <-- you mean, I have to cut the original wire? Sorry, a bit confused here...

Thank in advance

Post by **Spunkster** » Thu Jul 01, 2010 2:22 pm

spoonskywalker · Post by **spoonskywalker** » Thu Jul 01, 2010 11:48 pm

Done.. I follow the wiring as per instruction but still got the ELD error when I did datalog. Any ideas?

Post by **Spunkster** » Fri Jul 02, 2010 10:17 am

In Misc Parameters, disable the ELD error.