Derek (Doug?) or whoever else is out there... is there a way to get the Motec PLM setup info back up on the web page? I've been searching the web site, the forum, and Honda-Tech- and there isn't any information around. Reading through the Motec manual, S200 manual, and the HondaLogger manuals don't really help either.
http://www.hondata.com/motecplm.html = "File Not Found"
I need this set up because my car is going on the dyno tomorrow at Intercrew, and Phillip still doesn't have the wideband feeding into his laptop yet. I want to get everything hooked up so I can get a better tune instead of just watching the revs and the lambda meter values, then taking a best guess. It just takes too long, and partial throttle tuning is a pain.
I did find one post on this forum that said I would just have to plug the Motec PLM's cable into the blue box, then run a pre-made config file that's supposed to interface with the PLM without any issues... but I can't find the config file!
Can anyone help? Tuning starts at about 2pm central time...
Thanks for anything!
Mike