S300 showing 178 kpa

monkey · Post by **monkey** » Wed May 26, 2010 3:06 pm

Hi lads. could someone tell me if all s300 ecu should have atmospheric presure sensors built into them as im getting funny reading from mine. if they should have, i will post datalogs and other info on car.
cheers.

Post by **Spunkster** » Wed May 26, 2010 3:45 pm

What is the code on the side of your ECU?

monkey · Post by **monkey** » Thu May 27, 2010 1:38 pm

Thanks for your quick reply. The code is p28 g01
The Hondata chip code is S300-2881
there is a p30 code on the connector of ecu

Post by **Spunkster** » Thu May 27, 2010 1:46 pm

You will have to disable the baro error, and the injector error with that ECU.

monkey · Post by **monkey** » Thu May 27, 2010 2:07 pm

Cheers , i will check tomorrow.
just to let you know about myself.
i built this engine for my customer over a year ago and he flew a tuner from the states to tune this engine.
Im a technician, so im good with EOBD but only now have i looked into Hondata .
I must do some more checks and will report back.Cheers

Again thanks for your quick reply and help.

monkey · Post by **monkey** » Sat May 29, 2010 10:16 am

Hi Spunkster.
I can datalog no problem but cannot check to disable errors you instructed me to do.
when i go to misc in parameter , i dont have option to check the listed options.
Could you point in right direction please

Thanks in advance for your time .

Post by **Spunkster** » Tue Jun 01, 2010 9:40 am

You must load your calibration into the software to be able to make changes to it. You then must upload the calibration to the ECU when done.

monkey · Post by **monkey** » Sun Jun 20, 2010 11:55 am

cheers. thanks for your help.