launch control

michael 88 · Post by **michael 88** » Mon Jun 14, 2010 3:07 pm

prejudice I could explain step by step how to put the k-manager with the launch control? I go to rev limits then under the heading launch control tick enable launch control right? then what should I put in the entries below? such items in fuel & ignition retard activation RPM or fuel enrichment or ignition retard? with regard to what is presented from rpm and speed? 5000k and 15 km / h may be okay? Thanks for the help

michael 88 · Post by **michael 88** » Wed Jun 16, 2010 5:48 am

can someone help me? because I just can not understand how to put the launch, and do not understand that I have to put parameters. Thank you

Post by **Spunkster** » Wed Jun 16, 2010 9:23 am

http://www.hondata.com/help/kmanager/re ... ch+control

The settings all depend on your requirements and your personal preference. Please read the above help file.

michael 88 · Post by **michael 88** » Wed Jun 16, 2010 3:07 pm

ok thanks, I remain with only two questions for example, if imposed at the launch 6000k Fuel & Ignition retard activation RPM put the value of 5500 or should I put 6000? and last thing how to operate the launch control? friction drive, gear and full throttle? thanks again

michael 88 · Post by **michael 88** » Sun Jun 20, 2010 11:29 am

I said good or not? 'm no expert on the k-managers are beginning by

michael 88 · Post by **michael 88** » Tue Jun 29, 2010 9:52 am

may well go my reasoning?

michael 88 · Post by **michael 88** » Thu Jul 01, 2010 8:07 am

tried to put the launch control at 5500 rpm and Fuel & Ignition retard voice activation RPM 5000 I put in theory could be good? from what I understand the value of 5000 if all goes well or not?