need to stop Stalling on a k24k20 setup

jrkej1 · Post by **jrkej1** » Sun Jun 06, 2010 10:26 pm

Here's wat I have. Stock k24a1 block with stock k20a2 head with rbc manifold 70mm tb rdx 440 injectors need a calibration that will stop my car for stalling everytime I drive it from like 1800 rpm to 2000 rpm it stalls then drives off like crazy ...or if you rev it up normal the car stays at 2000rpm but if you open the tb it revs pass that .....any help will be good thanks

k20z3si4dr · Post by **k20z3si4dr** » Tue Aug 10, 2010 4:45 pm

post the calibration for us to take a look at.

jrkej1 · Post by **jrkej1** » Tue Aug 17, 2010 9:17 pm

here it is....not so good at this but i think it needs more fuel at low rpm....idk just saying