Shift light change

Team KLR · Post by **Team KLR** » Wed May 05, 2004 7:36 pm

I can't find where it tells me how to change the shift light engagement. I think that this is why the CEL light is on on the dash. The light stays on but there are no other problems with datalogging or emulating. I read in the fourm archives that this problem could be due to the shift light being set really low, like at 83 rpm's.

Thanks,

Mace Ward
Team KLR

shinociv · Post by **shinociv** » Wed May 05, 2004 9:11 pm

You can change the shift light engagement point in Hondalogger under the ECU tab.

boosted hybrid · Post by **boosted hybrid** » Wed May 05, 2004 9:17 pm

Are you connected to the ecu with the romulator? When i tune customers cars (anyone for that matter) with the romulator hooked up I get a steady CEL. Once the romulator is removed and the chip is burnt the light goes away. I have learned to ignore it for the past year or so.

Team KLR · Post by **Team KLR** » Thu May 06, 2004 4:07 am

I will check the shift light engaugement point and see if that is what the problem might be. If that is not it then I will chalk it up to the same issues that you are running into Boosted... Thank you for the help.

Mace Ward
Team KLR

Team KLR · Post by **Team KLR** » Thu May 06, 2004 3:54 pm

Hey Boosted....

As soon as I burned the customer's chip and installed it with his S200 box, the cel went off. Thanks for the advice.