s200 on 89 crx w/91' b18a / 92' LS ecu / obd 1 distributor

Team KLR · Post by **Team KLR** » Sat May 01, 2004 7:29 pm

I need info on specific wiring diagrams for the distributor wiring swap. The conversion harness is for a B16 not a B18A. It is to run a obd1 ecu with an obd0 car. Is the B16 harness going to pose any problems or will it work just fine with the nonvtec? Thank you.

Mace Ward
Team KLR

DaX · Post by **DaX** » Sun May 02, 2004 8:09 am

The harness will work, you'll just have a few dangling plugs [VTEC, Knock sensor]. Do a search on Honda Tech, I know I've seen the wiring diagram somewhere on there before.

Team KLR · Post by **Team KLR** » Sun May 02, 2004 10:48 am

thank you for the info.

Hondata

s200 on 89 crx w/91' b18a / 92' LS ecu / obd 1 distributor

s200 on 89 crx w/91' b18a / 92' LS ecu / obd 1 distributor

thanks