help please.. no cam advance

[leighep3]

My car is being mapped at the minute and the tuners has come across a problem the cam will not advance and is permantly set at 0% no matter what he tell it to be set at. can anybody help me asap please.
its a ukdm ctr k20a3 running a turbo conversion. i really need help.

thanks leigh

[Spunkster]

http://www.hondata.com/forum/viewtopic.php?t=3629

[leighep3]

car. ukdm ep3
hondata kpro ... serial number 37820-pra-e12 187213-4105
k manager 1.4.0.0

short spec is turbo(t04) rc 650cc injetors, 4bar map sensor,


description of fault is set low and high cam to 30deg run car on dyno cam commander is 0 deg and cam is 0deg.it will not let me adjust. always satys on 0 deg?

Can anybody please help with me for idea`s

[Hondata]

VTC is disabled because of error codes. There's three main problems:
- IAT sensor error
- primary o2 sensor error
- a PRB calibration was loaded into a PRA ECU.

[leighep3]

VTC is disabled because of error codes. There's three main problems:
- IAT sensor error
- primary o2 sensor error
- a PRB calibration was loaded into a PRA ECU.

yeah i thought so mate. thanks for your help..
the IAT error is because the sensor needs to be placed in the intercooler piping just before the intake i think?
the primary 02 error fault is because it currently had a wideband in the exhaust instead of the 02 sensor. and its running open loop atm..

thanks again for your help

[tommykair20]

2002 civic Ep3 "kpro PNF"
k manager v 1.4.0

ep stock intake manifold
k24a2 engine stock from a 04 tsx
t3/t4 turbo Stage III
650cc
9.5 lb flywheel
stage 4 clutch

my tuner command cams to 35 degree but it will only go and stay lock to 21 degree...

is it possible that my vtc gear is damage???

[Hondata]

A TSX engine has a 25 degree VTC.