Civic Type R EP3 - What Map?

[Honda Malta]

Hey guys,

Have been reccomended to get some info on this forum..

I have the following modifications:

ITG Maxogen
RBC Inlet
Kidd Race Header
Fujitsubo RM01A
Kpro (Still to Install and Map)

Could anyone suggest what would be my best map to opt for please?

Much appreciated,

Nigel

[gigaCTR]

hey where are you based?

What ECU Type?

Wideband O2 Sensor?

[Honda Malta]

Hey gigaCTR,

I am from Malta (small rock underneth sicily)

I have a Kpro PRA ECU soon to be installed onto the car.

Am a bit lost at the moment with how to map it or what map to use etc etc

Was wondering if anyone could help me out to get the most out of my mods...

Thanks,

Nigel

[gigaCTR]

hey nigel!

if you want to get the most out of your car you will need a local dyno (or street) tune.
if you want to learn and do it yourself you will need a wideband oxygen sensor. (i would buy one anyway)
without checking afr with that sensor it isnt even safe to drive any map.
maybe someone can send you a kal close to your mods...

[Honda Malta]

Ahh i see...My mechanic installed the kpro yesterday. He uploaded the honda tuned map...he altered high speed fuel and ignition. He also lowered the vtec point from 5100 to 4900 and rev limitor from 8100 to 8500.. would this map be right for my mods??

Someone please help, dont want to mess the car up!

[gigaCTR]

hey again
Did he check your AFRs?
With the tuned map you will be running lean at WOT with your RBC!
But you will be safe if you do not kick the car,
at light engine load you should be in closed loop anyway.

so get tuned asap!

[keto06]

A) Get wideband o2 sensor if you dont already have it
B) post a datalog including Wide Open Throttle 3rd gear pulls