closed loop operation

allm0t0rGSR · Post by **allm0t0rGSR** » Tue Mar 23, 2010 12:28 am

at the parameter, Maximum Map for closed loop, if i set it to 800mbar so if more than 800 mbar the closed loop operation will be disable, and it will go to open loop operation, and the short term and long term will be at 0%? so it wont affect my tunning at WOT?

correct me if i am wrong?

Post by **Spunkster** » Tue Mar 23, 2010 9:31 am

Correct as long as your long term trim is always 0 then it will not affect WOT tuning.

allm0t0rGSR · Post by **allm0t0rGSR** » Tue Mar 23, 2010 2:57 pm

Spunkster wrote:Correct as long as your long term trim is always 0 then it will not affect WOT tuning.

thanks....

so you mean even do the cloosed loop operation is already disable at 800mbar over, the long term will effect my wot tuning?if that so is there anyway to diable it? why there is a long term?what has been happened when theres long term?

Post by **Spunkster** » Tue Mar 23, 2010 4:13 pm

The only way is to run in open loop. Long term trim means that it has had to add or subtract fuel based on the closed loop settings.

allm0t0rGSR · Post by **allm0t0rGSR** » Tue Mar 23, 2010 6:52 pm

ok thanks alot