Is VTEC engaging?

ej6.sean · Post by **ej6.sean** » Sat Feb 06, 2010 3:58 pm

I am new to s300 and cannot tell if my vtec is working? I get a spool error if its not disabled could it be the pressure switch?
Thanks
98 civic dx, 2000 y7 block, jdm d15b head, 98 ex engine harness, OBD1 to obd2 dizzy step up harness, s300 obd1 non vtec dizzy leg is cut, off timing a little

Post by **Spunkster** » Mon Feb 08, 2010 3:56 pm

According to the datalog, the ECU is sending a signal to activate VTEC. Beyond that I cannot tell anything from the datalog.

ej6.sean · Post by **ej6.sean** » Thu Feb 11, 2010 11:00 am

Hmm thanks for looking. I have right dizzy on now, drove and its still not cracking. Can't I hook up a test light to a wire that goes to the ECU C15 I think??

Post by **Spunkster** » Thu Feb 11, 2010 3:26 pm

Try the ECU in a known working vehicle.

ROMEO856 · Post by **ROMEO856** » Sat Mar 13, 2010 9:06 pm

it shows that your vtec pressure is not on...