Since I've installed the OBX ITB's, my datalogging is a little strange.
Some parts of the table are not being filled with the lambda values.
As you can see, when I open the graphs, the values are being datalogged ok, but not shown at the tables.
The calibration is full TPS dependent. Ignore the crazy MAP signal, I only have vacuum reference of cylinders 1 & 4.
I'll post my calibration and the datalogging so you can see what is happening.
Thanks.
Datalogged lambda not shown on the tables
-
leandro_wez
- Posts: 7
- Joined: Tue May 26, 2009 9:14 pm
- Location: Brasil - Rio de Janeiro
- Contact:
Datalogged lambda not shown on the tables
You do not have the required permissions to view the files attached to this post.
race it, break it, fix it and repeat.