Noobie question

Headparrot · Post by **Headparrot** » Tue Jan 19, 2010 5:25 pm

Flamesuit is on.

I cannot activate the "parameters" section of the SManager. For instance, I want to adjust my lower Vtec level to 4500rpm...but can't because the parameters section will not allow me to check boxes or input manual data.
What's going on here? Is there a box I need to check/uncheck to allow me to adjust paramters???

I read the trouble shooting stickies on this forum and my s300 is installed correctly.

Yes. I have seached this forum.
Help will be most appreciated.

Post by **Spunkster** » Tue Jan 19, 2010 5:37 pm

You have to load the calibration you are using into the software.

Headparrot · Post by **Headparrot** » Tue Jan 19, 2010 8:10 pm

Cool....

I have B18C5 built with a b16 head...

Do you recommend calibration file: stockusp72.skl

or ITR file???