S300 Upload Issues

s300 and SManager software questions & answers
Post Reply
ls/vtec
Posts: 7
Joined: Fri Dec 25, 2009 12:30 am

S300 Upload Issues

Post by ls/vtec »

Hey guys,

Im trying to upload the StockusP72 calibration or any calibration but it wont let me upload as it is coming up with the message 'failed to upload, please try again'

I have also tried a different laptop which difinitely works with Smanager.

Its a P72 ECU with S300
1994 Integra GSR B18C

It did upgrade its firmware but cant upload ever since or reinstall firmware.

It shows its online aswell, the actual ecu has a solid red light if that helps

Any suggestion as it is annoying me now as I cant use the Hondata S300
lowblow
Posts: 86
Joined: Thu Dec 10, 2009 2:19 pm
Location: bay area ,CA

Post by lowblow »

Sounds like you have socketing problem.
Where you got your P72/S300 from?
ls/vtec
Posts: 7
Joined: Fri Dec 25, 2009 12:30 am

Post by ls/vtec »

I brought it used from a mate,

it was socketed by speedfactor in NZ which is suppose to be a NZ dealer.

Could I take it back to them to fix for free even though its been a year or 2 now?
User avatar
Spunkster
Site Admin
Posts: 23878
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata

Post by Spunkster »

From Help, About, what version of software are you using?
ls/vtec
Posts: 7
Joined: Fri Dec 25, 2009 12:30 am

Post by ls/vtec »

Spunkster wrote:From Help, About, what version of software are you using?
1.4.4.1
User avatar
Spunkster
Site Admin
Posts: 23878
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata

Post by Spunkster »

Please only post in one location.

It sounds like it may be an ECU socketing problem. I would recommend takign back to whoever socketed it to have them take a look. They should be able to swap it into a different ECU for testing as well.
sikyota
Posts: 9
Joined: Sun Mar 04, 2012 3:48 pm

Re: S300 Upload Issues

Post by sikyota »

i have this exact issue. i can access the ecu and update my name and information but i will receive my socket tester tomorrow and make sure the socketting is correct then if not i will be making a thread about my concern but i have the same p72 ecu was virgin before i soldered it.. and i have a 1994 gsr b18c1
User avatar
Spunkster
Site Admin
Posts: 23878
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata

Re: S300 Upload Issues

Post by Spunkster »

From Help, about, what version of software are you using?
solod3vil
Posts: 1
Joined: Fri Mar 30, 2012 2:39 am

Re: S300 Upload Issues

Post by solod3vil »

Hey names jay.The computer is no good (s300) I have the same problem. You gotta open up the hondata n check it there are two boards.they have the big board on the bottom n one on top of it that's about a quarter of the main bored.the problem is that the redencer goes bad quick I bought 3 hondatas to fined this out.The red light meaning its going into safe mode witch can really mess up ur car.get it fix asap.Green light is good u already know
Post Reply