J12 and new s200 install??

t2000si · Post by **t2000si** » Tue Mar 16, 2004 8:04 pm

I just recieved my p28 and s200 from Hondata. It looks like the p28 is setup already except the J12 spot isn't cut. Do I have to cut it before installing? Also I recieved 2 resistors/ capacitors with my chip. One with a black stripe and one with red & brown stripes on it. Do I need to do anything with these since my ecu was socketed from Hondata? I did a search and read the install manual but I am still unsure. Any help would be great. Thanks.

t2000si · Post by **t2000si** » Wed Mar 17, 2004 7:27 pm

After searching some more I found out I don't need the 2 capacitors that came with it. Although I'm still very confused on this J12 connection. Half the posts say cut it the other half says don't cut. Anyone know for sure?

turbosi92 · Post by **turbosi92** » Thu Mar 18, 2004 6:57 am

t2000si wrote:After searching some more I found out I don't need the 2 capacitors that came with it. Although I'm still very confused on this J12 connection. Half the posts say cut it the other half says don't cut. Anyone know for sure?

Search a little more.

viewtopic.php?t=430&highlight=j12

Post by **Spunkster** » Thu Mar 18, 2004 2:21 pm

http://www.hondata.com/s200.html

read the bottom of the page