D16Y8 Basemap

Calibrations for S-Manager - Use all calibrations at your own risk (dyno tuning recommended)
Locked
Bijiont
Posts: 6
Joined: Wed Aug 19, 2009 10:03 am

D16Y8 Basemap

Post by Bijiont »

Hello Everyone,

I am looking for a basemap for the following setup;

D16Y8 @ 10 PSI default timing of 12.
Stock Internals
RC 310 CC Injectors

I have tried to build a basemap off the P28 Z6 but there are so many differences that I am changing almost everything to get his car even close to 14.7 (idles currently at 15.1 boosts at 12.8)

Currently just dropping the IGN timing about 8 steps to get it in the 12 degree range and modify fuel but it still run 15.1 or leaner.

If someone has a NA basemap that would be great. Even something that gets me closer to a base then z6 would be a huge help. I could be tuning this thing for days to even get it close.

Thank you for any information you can provide even if it "go here and read". Yes I have also checked the built in calibrations and again, P28 Z6 is the closest thing there is.
khmoe
Posts: 12
Joined: Wed Jun 17, 2009 2:02 pm

Post by khmoe »

I never got any help in here with my D16y8. But this i have found out.

Put a d16z6 cam gear on your motor and start basetimming between 12-16 degree. Because if you are running obd2/d16y8 gam gear it will mess up you mind. 12 degree on the timming light is 21,75degree inn hondata.
Locked