Knocking with Reflash

Itsuki · Post by **Itsuki** » Wed Oct 14, 2009 1:52 pm

Hi,

I uploaded a datalog with the Reflash GroupN for the Euro Civic FN2.

My mods are:

CAI, RRC, 70mm TB, TB spacer, decat and 2.5" exhaust.

It´s supposed that the reflash was optimal with this mods. Why are this knocks?

Thanks

Post by **Spunkster** » Wed Oct 14, 2009 2:19 pm

The flashpro is tunable to allow you to tune out any problems and to tune it on the dyno for maximum gains.

Itsuki · Post by **Itsuki** » Thu Oct 15, 2009 7:06 am

Spunkster wrote:The flashpro is tunable to allow you to tune out any problems and to tune it on the dyno for maximum gains.

Sure 8)

Nitro1018 · Post by **Nitro1018** » Sun Oct 18, 2009 2:10 am

So, reflash GroupN (FlashPro) can be used without problem? It's the same like Group N ECU?

tp · Post by tp » Mon Oct 19, 2009 1:27 am

Safe to use...yes .... as a base map.
Never going to be optimum as every car is different and needs setting up for your car on a dyno for best gains and performance.

Nitro1018 · Post by **Nitro1018** » Mon Oct 26, 2009 1:52 am

tp wrote:Safe to use...yes .... as a base map.
Never going to be optimum as every car is different and needs setting up for your car on a dyno for best gains and performance.

Thank's for your reply, but does Group N calibration the same like Group N ECU?

I read in forums, Group N calibration from FlashPro is bad...