woundering about the BASE MAPS

eg6-k20a · Post by **eg6-k20a** » Wed Sep 30, 2009 2:08 pm

what`s the difference in the K20A2 base map to a K20A base map, is it just in the VTEC column? or is there any other settings thats special from one another?

thanks in advance

Post by **Spunkster** » Wed Sep 30, 2009 2:45 pm

The engiens have different pistons, cams, intake manifold and have different compression ratios.

eg6-k20a · Post by **eg6-k20a** » Wed Sep 30, 2009 3:05 pm

so if i was to load a base k20a2 map on my k20a engine would it be ok to tune it from there? like i know the internals are different but the calibration wise for it to run properly is there differences. thank you

Post by **Spunkster** » Wed Sep 30, 2009 3:31 pm

It is completely up to you what base map you use

It is best to use one that is closest to your setup.