Can Hondata please answer this?

fantasy_blu_boi · Post by **fantasy_blu_boi** » Wed Sep 16, 2009 2:01 am

Hey there hondata,

I have an 08 civic si with the following modifications:

injen CAI
Vibrant ... header
Vibrant 2.5 catback exhaust
Skunk2 Stage 2 cams with the valvetrain upgrade.

I saw on 8thcivic.com that you had the new skunk2 stage 2 calibrations maps available for the flashpro for this setup. I was wondering if those dyno graphs were made using the skunk2 stage 2 cams calibrations upload alone, or were there extra additions and fine tuning that you did to acheive 250+ hp on the dynapack???

What I'm trying to ask is if you've created a calibration map that doesnt need additional tweaking and get almost the same results? Is it just a quick upload and Flash and I should be getting close to the same results?

Post by **Hondata** » Wed Sep 16, 2009 8:09 am

The calibration distributed with the software is the same as that which was developed on the dyno.

Garrett_si · Post by **Garrett_si** » Thu Sep 17, 2009 9:42 am

each setup is different, go to the dyno and made a full tuned of your car

JEA86 · Post by **JEA86** » Fri Sep 18, 2009 1:26 pm

Garrett_si wrote:each setup is different, go to the dyno and made a full tuned of your car

thats so true.

I grabbed one of my buddies "dyno" tunes and i had to make some additional tweaks to get it to run completely correctly.