Red light by datalog port.

boostedpumpkin · Post by **boostedpumpkin** » Fri Aug 14, 2009 5:51 pm

my red light comes on while driving. i cant pin point it to a specific cause but it doesnt seem to affect how the car runs. i have checked with my laptop and has no codes. it doesnt ever come on consistantly like at vtec or full boost or anything i can figure out. this is while not datalogging. i am using the newest version,i checked for updates as soon as i put my ecu in and hooked my laptop up. anyone know what it might be?

thanks

john

Post by **Spunkster** » Mon Aug 17, 2009 9:22 am

In your calibration do you have on-board datalogging enabled?

boostedpumpkin · Post by **boostedpumpkin** » Mon Aug 17, 2009 1:57 pm

yes. today on the way home from work the light came on at full boost but it doesnt always come on then and it will go out on its own sometimes and sometimes stays on. im baffled.

Post by **Spunkster** » Mon Aug 17, 2009 2:14 pm

Turn off on-board datalogging

Jaker · Post by **Jaker** » Mon Aug 17, 2009 11:48 pm

Is on board datalogging working properly with any of the most recent software releases?

Post by **Spunkster** » Tue Aug 18, 2009 9:17 am

It works fine, but many people have it turned on thinking it must be turned on in able to be able to datalog using the laptop, and it does not need to be enabled.

boostedpumpkin · Post by **boostedpumpkin** » Tue Aug 18, 2009 2:43 pm

ill try that.

thanks

boostedpumpkin · Post by **boostedpumpkin** » Tue Aug 18, 2009 4:25 pm

problem fixed. thank you very much.