red light inside the ecu

boosted93coupe · Post by **boosted93coupe** » Wed Aug 12, 2009 9:16 pm

ok i can not figure out why the red light is on inside my ecu instead of the green one....the other day one of the wires came off my map sensor and i think it might have touched one of the other wires so i dont know if that would do anything or not and i switched main relays and i checked all my grounds i dont know wut else could be wrong

kinetics · Post by **kinetics** » Thu Aug 13, 2009 6:35 am

Red light is the datalogging LED, I believe.
Blinks when you're datalogging. Solid when onboard datalogging is turned on.

Post by **Spunkster** » Thu Aug 13, 2009 10:15 am

Can you still upload and datalog and is it working normally?

boosted93coupe · Post by **boosted93coupe** » Thu Aug 13, 2009 10:30 am

Spunkster wrote:Can you still upload and datalog and is it working normally?

i havent tried to datalog the red light is on even when its not plugged in.....it just all of a sudden came on without me even havin the computer plugged in

boostedpumpkin · Post by **boostedpumpkin** » Thu Aug 13, 2009 6:22 pm

my red light comes on while driving. i cant pin point it to a specific cause but it doesnt seem to affect how the car runs. i have checked with my laptop and has no codes. it doesnt ever come on consistantly like at vtec or full boost or anything i can figure out. this is while not datalogging.

boosted93coupe · Post by **boosted93coupe** » Thu Aug 13, 2009 7:50 pm

yea i checked today and i cant upload anything it just has an error....i can download from the ecu but not upload anything to the ecu

Post by **Spunkster** » Fri Aug 14, 2009 9:31 am

What version of software are you using from Help, About?

boosted93coupe · Post by **boosted93coupe** » Fri Aug 14, 2009 11:17 am

i just downloaded the new version and it still didnt help

Post by **Spunkster** » Fri Aug 14, 2009 11:22 am

you still have not answered the question, what version were you using?

boosted93coupe · Post by **boosted93coupe** » Fri Aug 14, 2009 3:58 pm

s300 in a p06 converted to vtec...is that wut ur talkin about by version?

boosted93coupe · Post by **boosted93coupe** » Fri Aug 14, 2009 11:59 pm

the version i am using is 1.4.2.0

Post by **Spunkster** » Mon Aug 17, 2009 9:38 am

Since you have now upgraded, please go to File, New or click on New Calibration and choose teh very first calibration. Upload that to the ecu and see if you can datalog.

boosted93coupe · Post by **boosted93coupe** » Wed Aug 19, 2009 7:21 pm

i tried that and it wont upload the new calibration to the ecu

Post by **Spunkster** » Thu Aug 20, 2009 12:14 pm

Please email support at hondata.com to obtain an RMA number and include a link to this thread.

boosted93coupe · Post by **boosted93coupe** » Fri Aug 21, 2009 5:38 am

whats there email address?