raised compression over 12:1.

silverspoon1996 · Post by **silverspoon1996** » Mon Jul 06, 2009 3:28 pm

Is it possible to get a basemap for higher compression?? I am knocking off idle and cant figure it out.

Garrett_si · Post by **Garrett_si** » Mon Jul 06, 2009 4:11 pm

you need tu adjust the calibration

increase duty cycle, and reduce ignition timing

silverspoon1996 · Post by **silverspoon1996** » Mon Jul 06, 2009 5:17 pm

That sounds all fine but im not a tuner, I am just looking for a basemap to drive to the tuner. As of right now im using the race map on map setting for the K&N v2 and RH. I am going to attach my datalog so someone can take a look it breaks up in first gear and has a hessitation around 3000 rpm.

silverspoon1996 · Post by **silverspoon1996** » Sun Jul 12, 2009 4:04 am

I figured out part of the problem... I was 2 quarts low on oil from all the revving I had been doing lately... It fixed the hesitation. I am still however getting up to 6 degrees knock retard.

k20z3si4dr · Post by **k20z3si4dr** » Wed Dec 16, 2009 11:32 am

silverspoon1996 wrote:I am still however getting up to 6 degrees knock retard.

thats why you do what garrett si told you to do.