DBW error

Hondata1 · Post by **Hondata1** » Mon Jul 06, 2009 11:10 am

U0170 is generated by the stock ECU which controls the drive by wire. The OBD II scan tool is connected to the stock ECU and not the K-Pro.

Check the small drive by wire ECU connector is plugged in firmly and to the correct plug.

The Boost-a-Pump testing was done with the pump permanently wired to run 18V. We recommend using the manifold pressure switch.

Boofster · Post by **Boofster** » Mon Jul 06, 2009 5:29 pm

The "correct" DBW plug being on the stock ECU and NOT on the harness.

Read this:
http://www.hondata.com/downloads/KPro%2 ... 0S2000.pdf