How to fix knock w/ cal

K-Series Programmable ECU installation questions / support issues
Locked
schoe
Posts: 15
Joined: Thu May 14, 2009 3:55 pm

How to fix knock w/ cal

Post by schoe »

I did a datalog and came up with 81 knocks pulling on 3rd gear (even though the kmanager says 4th)... How do I go about fixing this because it looks like its running alittle rich at 11-12:1... Do I add fuel to that to make it close to 14??? Also, the VTC is supposed to advance to 45 degrees but it only advanced to 40 when i let off the gas... I just would like to bring it to a point to safe to drive until I get everything together for a tune... Thanks in advance!
You do not have the required permissions to view the files attached to this post.
User avatar
Spunkster
Site Admin
Posts: 23887
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata

Post by Spunkster »

If you get detonation then you must remove timing from the areas of the map where the detonation occurs.
Locked