cranny... need yer help again with JDM tune
hills are good for the long ones. when your just driving normally , if you look at TABLES while datalogging , youl notice the 4 red squares will live in the area of , rpm 1250-4500 , columns 2-7. what i want you to do , make the 4 red squares pass over all the areas where i just told you mulitple times during the 20-30 minute datalog. you let me know when your ready to do long ones cause i have to set your calibration to do it.
heres WOT update:
heres WOT update:
You do not have the required permissions to view the files attached to this post.
did a 20 minute datalog, went up to a nearby village. let me know if anything's missing. i also included a bit of highway driving, thats how i drive to university most of the times, 6th and 5th gear. by the way, the car feels pretty slow in 5th and 6th compared to other type r's, from 180kph to 220 its almost like stock, and when i get to 220 and engage to 6th the needle just doesnt move. it might be my imagination, i dunno.
You do not have the required permissions to view the files attached to this post.
here's a WOT, a few knocks. i did mention i had a hole in my exhaust last time i datalogged, but now i installed the stock backbox instead of my supersprint, but to be honest it actually feels LESS restrictive. if its the fuel let me know.
You do not have the required permissions to view the files attached to this post.
yes give me another part throttle datalog , make sure its in open loop. 20 mins or so , vary driving conditions please as much as possible , get around the map. throw a WOT pull in it of course. most of the knock is happening in part throttle , i backed up timing a little bit in areas of WOT as you had a few knows there too , nothing major.
You do not have the required permissions to view the files attached to this post.
did both a WOT and a 20 min. lots of knocking past 6k rpm at full throttle. part throttle seams okay to me... my car felt faster a few months back, but im guessing thats only because its much warmer now. i thought temperature would only affect an f/i engine to this extent, guess im wrong.
You do not have the required permissions to view the files attached to this post.