S300 w/ Tunerview II and aem wideband issue

Turbo-LS · Post by **Turbo-LS** » Thu Jun 04, 2009 3:44 pm

Ok so i finally figure dout how to get the s300 to read the same a/f ratios or pretty close but when i load all that in and then hook up my tunerview II its reading 2-3 points higher. is there something in the s300 software i need to set as far as datalogging goes in order to get it to read the same as the wideband gauge?

Post by **Spunkster** » Thu Jun 04, 2009 4:07 pm

This sounds like an issue with the tunerviewII. I would contact them about it.