Ideas on setting up a map switching for pump/race gas

0piston · Post by **0piston** » Sun Apr 26, 2009 11:56 am

I've read on the S300 section you can toggle between maps by going Parameters > Secondary tables tab

Any suggestions on preforming this with my Kpro/kmanager?

I want to be able to switch between maps on the fly, one for pump gas and one for race fuel

or thinking

a switch between low boost/pump gas and for high boost/race gas

thanks for any ideas on setting this up

Post by **Hondata** » Mon Apr 27, 2009 7:49 am

There is not room in the ECU for two sets of tables. The hard part would be getting the vehicle to switch fuels on the fly.

0piston · Post by **0piston** » Mon Apr 27, 2009 8:55 am

If Hi/Low switch activated boost boost control was enabled, and there was also Nitrous switch setup to add or subtract fuel/ignition...

which one would trigger first, if all conditions are made equal?Could I get them to work together thinking about using these this combination to try to achieve what I am doing...

Post by **Hondata** » Tue Apr 28, 2009 7:50 am

Both at the same time. My point was that changing fuel is not an instant operation, so it would be possible to upload a different calibration.