3 BARS MAP SENSOR

rebohn · Post by **rebohn** » Sun Dec 14, 2003 10:55 am

I HAVE D16Z6 ENGINE I HAVE THE GM SENSOR WHAT CAN I DO STEP BY STEP , i install the sensor but check engine light its on this ignited that I must do so that the Ecu does not throw error to me of? that but I must modify jmiclos@hotmail.com

DaX · Post by **DaX** » Mon Dec 15, 2003 4:39 am

Are you boosting? How much PSI?

What stage hondata are you using?

rebohn · Post by **rebohn** » Mon Dec 15, 2003 8:08 am

no i dont have hondata i want to know what i need to install 3 bars sensor
i have the gm sensor with connector but i want to know chip on my ecu but i dont have hondata its the reason this post. please let me know
steps to install

i will put turbo in 1 week ?

DaX · Post by **DaX** » Mon Dec 15, 2003 1:45 pm

To use a 3 bar map sensor, you've got to have hardware to support it [like hondata or some other engine management]. You cannot simply wire a 3 bar map sensor into your engine harness and run it with the stock ECU.

rebohn · Post by **rebohn** » Tue Dec 16, 2003 12:27 am

ok what hardware i need? hondata ecu? only works with hondata system?

slowpokin699 · Post by **slowpokin699** » Tue Dec 23, 2003 3:12 pm

you can use either hondata or you can use a safc like us dsm'ers do.. for info:
http://www.dsmtalk.com/forums/showthrea ... map+sensor

you might need to be registered but thats all you will need to know.. there are a few links in that thread that are specifically for hondas too, they were just for refrence for the dsm guys but it's all the same theory.

Hondata

3 BARS MAP SENSOR

3 BARS MAP SENSOR

3 BARS MAP SENSOR

Re: 3 BARS MAP SENSOR