*Smanager Request*

crucian · Post by **crucian** » Fri Apr 17, 2009 6:49 am

Is it possible to have pressure values added to the Gear Compensation parameter. For example, I want to reduce timing in first and second gear but not all the time only when boost is over 5 PSI. This is for traction purposes reducing power in these gears. Thanks!

Post by **Hondata** » Fri Apr 17, 2009 7:43 am

You can do this using a nitrous output. Set up an nitrous output with an always on input, a maximum speed for 2nd gear, no fuel change and some ignition retard.

crucian · Post by **crucian** » Sun Apr 19, 2009 10:27 am

Hondata wrote:You can do this using a nitrous output. Set up an nitrous output with an always on input, a maximum speed for 2nd gear, no fuel change and some ignition retard.

But a lot of factors matter like if I change gear early. Hmmmm, I'll see how it works out.