not able to upload. help please

[ThatGuy4life]

So I just picked up my car at the end of January after my most recent build was complete


Built 2000 B18C5-type R motor
2000 Civic Si tranny
Stage 2 port & polish head
Crower rods
wiseco piston kit 81.5mm-w/ rings 11.5:1 compression
Skunk 2 pro 2 camshafts
Skunk 2 pro series intake manifold
Skunk2 pro series valves and titanium retainers
Act Flywheel
RPS Six Puck Sprung Hub Clutch
Skunk2 Pro series Cam Gears
AEM Fuel Rail
AEM Fuel Pressure Regulator
Vission Fuel Pressure Guage
TrePerformance 255lph fuel pump
440cc fuel injectors
Skunk2 Cam Seal
Rage Tri Y header
Delete Cat
AEM V2 cold air intake
Skunk2 Mega Power R exhaust
NGK Blue Performance wires
NGK Iridum plugs
PWR half cut radiator w/ fan
Hasport motor mounts
Hondata S300

And some minor other tidbits.

around the beginning of March she threw a cel. Code 9. Called my shop who unfortunately is out of state and let my tuner know at which point he said might be my dizzy. I made the drive to the shop and spent 2 days there w/ them switching out the guts of my dizzy still couldn't get rid of the cel. finally they got a dizzy off a 94 gsr and switched the pins for obd2 wiring, still the same cel. So I drove back home ordered a new dizzy put that on last week tuesday same cel. Finally took it to one of the honda dealerships here as one of my friends works as a tech there. He tested everything and finally determined that the problem was with my ecu. So I ordered another P28, swapped over my S300, now the car won't start at all. Didn't have my laptop until just now.

Plugged in the ecu to my laptop and downloaded the graphs, seems as if it reset itself back to original settings. So I tried uploading my original calibration but I keep getting a message that says upload fail try uploading again. If it means anything I have one red led and one green led on the ecu

[ThatGuy4life]

here are the charts

[ThatGuy4life]

Disregard I've found the problem. Didn't have the s300 seated properly in the ecu.