datalog stops on dyno pulls

s300 and SManager software questions & answers
Locked
EGHATCH
Posts: 67
Joined: Wed Jan 12, 2005 8:16 am

datalog stops on dyno pulls

Post by EGHATCH »

street tunine at part throttle works with datalog, idle, etc. it never stops
but when i went to dyno earlier, at WOT, datalogging just stopps.

i have to discounnect and reconnect the cable and f10 again...

bkre9ix.
stock ign system
you wont learn until you actually do it.
Top
User avatar
Spunkster
Site Admin
Posts: 23878
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata

Post by Spunkster »

It may have non-OEM plug wires or cap and that may be causing the problem.
Top
crucian
Posts: 199
Joined: Sat Dec 10, 2005 9:42 am
Location: Lowville, NY

Post by crucian »

Why do we have to use OEM plug wires and Cap for a product we paid for to tune our cars?
Top
User avatar
Spunkster
Site Admin
Posts: 23878
Joined: Fri Sep 20, 2002 5:06 pm
Location: Hondata

Post by Spunkster »

Because they may produce large amounts of interference. This is not something we can control or change on our end. The OEM parts are made to very high spedifications and must meet certain criteria. Aftermarket ignition components do no have to meet these strict criteria and are known to cause problems. We have seen cars make over 900 hp with the stock ignition system.
Top
crucian
Posts: 199
Joined: Sat Dec 10, 2005 9:42 am
Location: Lowville, NY

Re: datalog stops on dyno pulls

Post by crucian »

EGHATCH wrote:street tunine at part throttle works with datalog, idle, etc. it never stops
but when i went to dyno earlier, at WOT, datalogging just stopps.

i have to discounnect and reconnect the cable and f10 again...

bkre9ix.
stock ign system
Also try a different USB port on your laptop if you haven't already done so.
Top
Locked

Return to “s300 / SManager”