in need of a base calibration for a fully built b16 for turbo.
motor is bored/decked/stroked
8.5:1 c/r 84.5mm cp pistons
eagle h-beam rods
b18b1 crank
stock head
rev hard manifold
airesearch stage 3 turbo
synapse wastegate and blow off
3 inch down pipe and 2 1/2 exhaust
750 cc rc injectors
eagle fuel rail
walbro 255 fuel pump w/ synapse fuel reg.
any help is much appreciated.
Need a base for fully built b16 turbo w/ 750cc inj.
-
cardinal811
- Posts: 123
- Joined: Tue Jan 02, 2007 11:18 am
SIR please trash the WG, they do not work
But the BOV you got a fine unit there
Whats your location and if your close to Cinn Ohio I suggest your call total performance racing or http://www.trpcincy.com and ask ROB to schedule you a 3hr block on the dyno
The best Tuner in the US and even "well PM me for more info" so it's not moderated. S300 right? If so excellent choice
But the BOV you got a fine unit there
Whats your location and if your close to Cinn Ohio I suggest your call total performance racing or http://www.trpcincy.com and ask ROB to schedule you a 3hr block on the dyno
The best Tuner in the US and even "well PM me for more info" so it's not moderated. S300 right? If so excellent choice