Setup question

Crxmanror · Post by **Crxmanror** » Thu Mar 12, 2009 8:36 pm

Under the Options tab is the choice Tables Follow Cam Angle suppose to have a check next to it? Downloaded new version and dont remember if this was checked. Uploaded map with new version and now car runs terrible.

cranny · Post by **cranny** » Thu Mar 12, 2009 8:58 pm

yes its better for tuning/reading datalogs. and tables follow VTEC should be checked too. this is of course my opinion.

Crxmanror · Post by **Crxmanror** » Thu Mar 12, 2009 9:12 pm

so do you think that if this was not checked the cam angle was not being adjusted as the engine went through the rev range?

Post by **Spunkster** » Fri Mar 13, 2009 10:04 am

tables following vtec in datalogging has nothing to do withthe way the car runs.