K-Pro Dual o2 sensor

Boofster · Post by **Boofster** » Sat Feb 28, 2009 1:57 pm

Application: '06 S2000

As per instructions, I picked up a primary o2 sensor from an '04 RSX.
Just to double check, the part number was 36531-PRB-A01

Trying to install it right now and it seems the harness is about 4" shorter than the stock s2k sensor. I can't find any slack to plug it in.

What are people doing in this case? Do I need to re-solder extend the harness or is there a trick I'm missing here?

cranny · Post by **cranny** » Sat Feb 28, 2009 6:00 pm

you can either make one if you have access to spare or parts harness's , or you can buy O2 extentions from a couple different sites.

Boofster · Post by **Boofster** » Sat Feb 28, 2009 9:27 pm

cranny wrote:you can either make one if you have access to spare or parts harness's , or you can buy O2 extentions from a couple different sites.

Thanks. I'm interested in those that have already installed it.

cranny · Post by **cranny** » Sun Mar 01, 2009 9:12 am

lol , ok.

Post by **Spunkster** » Mon Mar 02, 2009 10:57 am

It will fit just fine, but you must reroute the wires over the transmission instead of around the back of it like it is when stock.

Boofster · Post by **Boofster** » Thu Mar 05, 2009 2:21 pm

I popped another clip and was able to wire it reasonably well.

Fount this extension which may be exactly what we need to return to stock path:

http://www.clubrsx.com/cr/CLU-O2EXT.html

I will install and report back.