B16 with internalls + 780cc injectors + .50/.63

perico_asesino78 · Post by **perico_asesino78** » Wed Feb 04, 2009 10:25 am

Hi, could help me with a map?

b16a2 with internals
8.6 : 1
AR .50 / .63
ported and polished
stock camshafts & springs
regulable pulleys
light weigth pulles
flywheel
clutch stage 4
780cc injectors
S300
fuel pressure regulator
msd 6AL

Thanks!!!

cranny · Post by **cranny** » Wed Feb 04, 2009 6:30 pm

what PSI do you plan on running?

perico_asesino78 · Post by **perico_asesino78** » Wed Feb 04, 2009 9:30 pm

cranny wrote:what PSI do you plan on running?

I hope to get 20 psi using 106 octane gas and also with 91 octane a little bit psi I think

perico_asesino78 · Post by **perico_asesino78** » Wed Feb 04, 2009 9:49 pm

In my country (Ecuador) having a racing car is really difficult because there's nobody with enought knowledge to program hondata, fuel sucks and also doesn't even exist a dyno!! So that's why I'm asking for your help please!!

cranny · Post by **cranny** » Wed Feb 04, 2009 10:07 pm

how do you control your boost?

perico_asesino78 · Post by **perico_asesino78** » Thu Feb 05, 2009 6:16 am

cranny wrote:how do you control your boost?

External waste gate
Manual boost controller

I also forget to mention I have a 255 lph walbro fuel pump

cranny · Post by **cranny** » Thu Feb 05, 2009 6:44 am

what map sensor you running?

perico_asesino78 · Post by **perico_asesino78** » Thu Feb 05, 2009 7:45 am

motorola 2.5 bar MAP

thanks

cranny · Post by **cranny** » Thu Feb 05, 2009 9:39 am

this is the b16 greddy turbo basemap , i adjusted it for your injectors and map sensor. turn your boost down as low as it goes , start there. i enabled lean protection as well. see if the car runs normally , ALWAYS keep an eye out what your air fuel ratio is reading.

i assume you have a wideband wired up and ready to go?

perico_asesino78 · Post by **perico_asesino78** » Thu Feb 05, 2009 10:05 am

not yet, I have an auto meter air/fuel meter

cranny · Post by **cranny** » Thu Feb 05, 2009 10:22 am

you need a wideband , dont drive the car till you get one , youl blow it up.

perico_asesino78 · Post by **perico_asesino78** » Thu Feb 05, 2009 10:25 am

thanks... the next week I'll install the wideband...

perico_asesino78 · Post by **perico_asesino78** » Thu Feb 05, 2009 10:40 am

Could use only the 5 wires sensor or I'll need the wideband gauge?
Thanks...

cranny · Post by **cranny** » Thu Feb 05, 2009 11:01 am

you need the gauge too as it controls the sensor. hondata recomends the PLX.

perico_asesino78 · Post by **perico_asesino78** » Thu Feb 05, 2009 1:43 pm

Thanks again Cranny... could you send me your email?