Proper TPS Readings - Settings

Crxmanror · Post by **Crxmanror** » Wed Jan 07, 2009 5:19 pm

I'm new to K-Pro and have a question related to the TPS readings im getting. According to K-Pro when the car is at idle it reads 0% which is correct. Now when you push the pedal to the floor it reads 102%. Is this correct? Is there any changes in the software that I may need to change?The TPS has never been messed with that I know of so I assume this is how it came from the factory.

Post by **Spunkster** » Wed Jan 07, 2009 5:42 pm

A reading of 102 at WOT is fine and will not cause any problems.

Crxmanror · Post by **Crxmanror** » Thu Jan 08, 2009 4:04 pm

thanks for the info...

fonz600 · Post by **fonz600** » Thu Jan 08, 2009 4:55 pm

If you have acopy off your map you could make sure the Scale TPS readings are correct as they sit at 0 and 100 normally on the base maps.

It's under Parameters, Knock/TPS then just hit read on each off the throttle settings to set it to your car and then save it and re upload.