S300 problem

hp1 · Post by **hp1** » Sun Nov 30, 2008 10:31 am

I have a P06 w/ S300, I cannot get the ECU to throw a check light. I have unplugged random sensors to try and get a check light but no luck. Any ideas? car runs fine... thanks

Post by **Spunkster** » Thu Dec 04, 2008 11:24 am

you may have a burned out bulb.

hp1 · Post by **hp1** » Sat Dec 06, 2008 10:55 pm

Light bulb is good, I see it coming on at start up. Have you ever heard of a problem like mine? tia

Post by **Spunkster** » Tue Dec 09, 2008 10:20 am

Do you get error codes when you datalog?

hp1 · Post by **hp1** » Wed Dec 17, 2008 10:19 pm

Hey, I do not get error codes while in datalog. I now can get a couple sensor to throw a CEL but that's about it. help

Post by **Spunkster** » Thu Dec 18, 2008 11:22 am

does the mil light come on if you set the shift light to 2000 RPM and rev the car over 2000 RPM?

hp1 · Post by **hp1** » Sun Dec 21, 2008 10:02 pm

Yes, CEL light comes on with shiftlight @ 2K.

Post by **Spunkster** » Mon Dec 22, 2008 10:45 am

Then it does not sound like there is a problem.