respose

PR8urvtec · Post by **PR8urvtec** » Sun Dec 07, 2008 11:46 am

Yeah, I was looking on the Smanager software and saw there is a P74 base map. The problem is that they didn't socket my ECU with the computer. They just modified it to take the S300 unit. So I started the car with no map im guessing. SO, I Went to socket the ECU with the unit and cut the USB opening in the caseing But they didnt follow the instructions when modifing the ECU and they didnt install the prongs in the rights spot. So, I could not install the chip. IT is very frustrating.

Here is a pic.

See what im talking about.

FreshDA9 · Post by **FreshDA9** » Mon Dec 08, 2008 9:46 am

well the cn2 is in the wrong spot 1-4 should have the male pins and #5 should be empty.

J1 should have a straight jumper it looks as some kinda resistor is in its place. R54 looks right. C51 and C52 doesnt look to be installed.

get those fixed and put the s300 in and load a basemap and go get tuned.

PR8urvtec · Post by **PR8urvtec** » Mon Dec 08, 2008 11:04 am

I will contact the installer and see what he says about this. I know he has installed this before plenty of times. I would want him to folloe the proper way of doing this though. Thanks for your imput.