jdm dc5 speedo problem with kpro

honda crazzy · Post by **honda crazzy** » Mon Oct 27, 2008 12:50 pm

jdm itr with euro ctr tranny. my speedo under reads alot!
is there any way to change the pulses from the speed sensor with kpro. the option to use the countershaft speed signal and change values does not work.
someone please advise

Post by **Spunkster** » Mon Oct 27, 2008 1:47 pm

No, it is not possible to change the calibration of the speedo with the ecu.

honda crazzy · Post by **honda crazzy** » Mon Oct 27, 2008 2:53 pm

if i use the healtech speedohealer(which alters the pulses from the speed sensor), should i fit it between the speed sensor and the dash, or must the ecu also read this calibrated pulse? will the ecu actually make sense of the "altered" signal ?
is it compulsary for the ecu to read this changed signal, cause i don't use gear compensation anyway

Post by **Spunkster** » Tue Oct 28, 2008 9:34 am

The ECU must read 4 pulses per wheel revolution.

honda crazzy · Post by **honda crazzy** » Thu Oct 30, 2008 11:15 pm

i hooked up the speedohealer just after the speed sensor. all works well. calibrated it and both kpro and speedo are 100% in check!