CEL and datalog not working?

[A-Dev]

Just got a CEL on my way home tonight, pulled out the laptop to check the code. Kmanager is Online, I can upload kals, but when i datalog to pull codes or check sensors, nothing happens.

When i shut the car off the CEL goes away, when I start the car up or turn the key to the on position after about 10 secs it comes back up.

Can anyone help me?

[Spunkster]

Try clearing security (online, tools, clear security), then close the program, reopen the program, go to File, New and create a new base calibration and then upload it and see if it will datalog.

[A-Dev]

still no datalogging

cleared security, uploaded base map, no datalogging, uploaded tuned map, still no datalogging. :?

edit:
yes i closed then reopened the program, and I let the ECU sit for at least a minute between uploads.

[A-Dev]

took the car for a drive, it's in limp mode. 4000rpm rev limit, cel, no datalogging. anyone know to get it out of limp mode, it comes on everytime i start the car

[A-Dev]

updated usb drivers, closed kmanage , restarted computer, uploaded cal, still the same, limp mode with no datalogging and cel

[Hondata]

http://www.hondata.com/forum/viewtopic.php?t=3629