I downloaded update for kpro and now my car wont start HELP?

EK_K20R · Post by **EK_K20R** » Wed Sep 17, 2008 5:09 pm

So I just downloaded the newest version after my 2.16 and now that I updated my software to 2.18 my car wont start.

I downloaded from my ECU first then I uploaded it back into the ECU and this is the outcome...

Any HELP???

Or tips on what I should do.....?

Juni

fonz600 · Post by **fonz600** » Thu Sep 18, 2008 2:59 am

Downloading the map from your ECU should be done with caution as problems can arise.

Try clearing your security, switch off ignition, clost down kmanager then restart it again and switch on ignition and uploading it again.

If not working try and upload a map from the calibrations folder similar to your mods and see if it'll start.

If still got probs uninstall kmanager and do a fresh install.

EK_K20R · Post by **EK_K20R** » Thu Sep 18, 2008 4:08 am

fonz600 wrote:Downloading the map from your ECU should be done with caution as problems can arise.

Try clearing your security, switch off ignition, clost down kmanager then restart it again and switch on ignition and uploading it again.

If not working try and upload a map from the calibrations folder similar to your mods and see if it'll start.

If still got probs uninstall kmanager and do a fresh install.

ok I will try that this evening...

Thank you!

EK_K20R · Post by **EK_K20R** » Fri Sep 19, 2008 3:57 pm

it worked.......thanks!

fonz600 · Post by **fonz600** » Sat Sep 20, 2008 3:25 am

No probs mate. Glad I could help.