FJO Wideband installation question

se93 · Post by **se93** » Sun Oct 12, 2003 9:44 pm

I have a doubt regarding the installation of the FJO unit. I got a hold of a dead O2 sensor plug, installed the resistor across both black wire, extended the white/green wires and connected it to the stock wiring harness. I took the gray wire of the FJO and connected that to the white wire coming from the dead O2 sensor plug. I installed the FJO ground wire together with the green wire (installed the diode as well) coming from the dead O2 sensor plug and the white wire from the FJO to a 12 volt source.

Is this correct?

Thanks,
Mark

DevineCRX · Post by **DevineCRX** » Mon Oct 13, 2003 11:20 am

ive never done it, but here is a article i found on interfacing the FJO and hondata.

http://www.boosted-hybrid.com/tech_articles/tech1.html

Post by **Spunkster** » Wed Oct 15, 2003 4:48 pm

You can also find some helpful info at http://www.hondata.com/techwidebandtuning.html