weird problem with P72...

HONDA GHANDI · Post by **HONDA GHANDI** » Sat Oct 11, 2003 11:31 am

Hey all, I have been installing these things for few months now and have very little problems. Today however I have one unit that is acting very weird. The setup is B20Vtec in a 94 civic with a USDM P72 Ecu. and S200-b. Installed the 3 bar MAP and wrote abasemap using the wizard. The car runs very well but it had a CEL. So I pulled the code naturally and its flashing a 23. (which doesnt exist in any of my books) has anyone had this problem or is the ECU FUBAR?

Post by **Hondata** » Sat Oct 11, 2003 4:12 pm

http://www.hondata.com/techecucodes.html

Code 23 = knock sensor

In RomEditor, disable the knock sensor.

HONDA GHANDI · Post by **HONDA GHANDI** » Sun Oct 12, 2003 9:35 am

Thanks, I found it too. I was looking in my civic book that doesnt list it.
Thanks again Hondata for answering my stupid question.