CAM Command always at 0

magnEsium · Post by **magnEsium** » Wed Aug 13, 2008 7:28 am

A friend just bought K-Pro, I gave him a kal for his vehicle and his cam command is always at 0, it does not change ever even though the tables say otherwise

No CEL's thrown, VTC is enabled, just simple bolt ons, 2005 rsx-s

Car is warmed up, all engine sensors were checked and rechecked

Any ideas?

Post by **Hondata** » Wed Aug 13, 2008 8:00 am

http://www.hondata.net/forum/viewtopic.php?t=3629

rdiablos330 · Post by **rdiablos330** » Wed Aug 13, 2008 8:26 am

how do i find the serial number? i cant find the paper..
06 rsx type s
kpro
injen cai, rbc manifold, sturp rh, tanabe catback
the problem i have is what magnesium said

Post by **Spunkster** » Wed Aug 13, 2008 10:37 am

open the lid and look at the K-Pro board.

rdiablos330 · Post by **rdiablos330** » Wed Aug 13, 2008 2:46 pm

4087 is my serial number

rdiablos330 · Post by **rdiablos330** » Thu Aug 14, 2008 7:17 am

so any comments on what could be wrong with the car??

Post by **Hondata** » Thu Aug 14, 2008 7:51 am

You have an error code - P0112 "IAT Sensor Low Voltage"

magnEsium · Post by **magnEsium** » Thu Aug 14, 2008 10:02 am

Hondata wrote:You have an error code - P0112 "IAT Sensor Low Voltage"

That wouldn't cause the angles to lock at 0, would it?

Post by **Spunkster** » Thu Aug 14, 2008 11:32 am

Yes it will.

rdiablos330 · Post by **rdiablos330** » Thu Aug 14, 2008 12:18 pm

ya thats the code.. so just get a new iat and im good?

Post by **Hondata** » Fri Aug 15, 2008 9:11 am

If there are an error codes always track down and fix them before doing anything else.

Follow the Helms manual troubleshooting for the IAT error code.

rdiablos330 · Post by **rdiablos330** » Fri Aug 15, 2008 11:26 am

i put in the new sensor and the code is still there. once i clear it it comes back on. when i clear it n dont let it idle on its own, by revving the car it stays off. but it works the whole time as long as i keep the rev high.. once i let it idle alone the engine light comes right back on and the kpro craps out.. what should i do? and i dont have the helms manual where can i get one?