Smanager querk - how do I get around this?

OTT · Post by **OTT** » Wed Jul 23, 2008 5:49 am

I use S300 on a Hondata socketed P28 with PWM circuitry.

In boost-control parameters:
When i try type boost psi in & percentages dutcy cycle in the lookup table it somtimes doesnt let me have the number I want there, Ill type it in then hit enter and as I hit enter the figure will revert back to either somthing that was there previously or a slightly different figure than i entered (like 12.9psi instead of 13psi)

Ive noticed that if I skip to a different page along the top then skip back it lets me change the next box, save, then change page at the top again and repeat the process. But it doesnt always let me put the number I want.

Is there some sort of logic I have to follow to set this up??

Thanks.

Post by **Hondata** » Wed Jul 23, 2008 8:09 am

Pressure values must always increase. eg if you enter 13 psi and the next value is also 13 psi, the value you entered will be decreased so there is no conflict. It is often easiest to enter values from highest to lowest. ie right to left.

OTT · Post by **OTT** » Thu Jul 24, 2008 2:29 am

Thanks for the advice dude, I'll soon be prepared for when mars attacks :D Ace.

Thanks again.

ps. please check your email /spam folder for an email with the subject ''Representing Hondata''. Id really appreciate you opinion or help with that! :idea: